986 Forum - The Community for Porsche Boxster & Cayman Owners

986 Forum - The Community for Porsche Boxster & Cayman Owners (http://986forum.com/forums/)
-   Off Topic Discussions (http://986forum.com/forums/off-topic-discussions/)
-   -   ISTA+ ICOM Next Connection Issues (http://986forum.com/forums/off-topic-discussions/86433-ista-icom-next-connection-issues.html)

Antoine86 10-11-2024 01:44 AM

ISTA+ ICOM Next Connection Issues
 
I'm experiencing connection problems with my F25 using the ICOM Next interface. I successfully connected directly to ISTA+ with an ENET cable but switched to bmw icom next for an ILEVEL upgrade.

In ITool Radar, I see the connection, and I can reserve the interface in Easy Connect. However, when I launch ISTA+, all connections drop and time out. Vehicle identification fails, and I receive timeout errors across all tools, including the web admin interface. Restarting the ICOM after disconnecting it from the car temporarily resolves the issue until I attempt to connect with ISTA+ again.

Specs:
- ICOM Next: ICOM A1 Firmware: 03.22.21 (clone)
- ISTA+: 4.32.15
- ITool Radar: 1.1.1 (working fine)
- Easy Connect: 7.3.0 (working fine)

I'm using a remote IP as per the guide, and all protections are disabled in Windows. The ENET direct cable connection works perfectly.

What am I missing? Any help would be greatly appreciated!

Starter986 10-11-2024 01:47 AM

Quote:

Originally Posted by Antoine86 (Post 663563)
I'm experiencing connection problems with my F25 using the ICOM Next interface. I successfully connected directly to ISTA+ with an ENET cable but switched to bmw icom next for an ILEVEL upgrade.

In ITool Radar, I see the connection, and I can reserve the interface in Easy Connect. However, when I launch ISTA+, all connections drop and time out. Vehicle identification fails, and I receive timeout errors across all tools, including the web admin interface. Restarting the ICOM after disconnecting it from the car temporarily resolves the issue until I attempt to connect with ISTA+ again.

Specs:
- ICOM Next: ICOM A1 Firmware: 03.22.21 (clone)
- ISTA+: 4.32.15
- ITool Radar: 1.1.1 (working fine)
- Easy Connect: 7.3.0 (working fine)

I'm using a remote IP as per the guide, and all protections are disabled in Windows. The ENET direct cable connection works perfectly.

What am I missing? Any help would be greatly appreciated!

Quit launching ISTA+[/U][/B][/B], dumbass. :cheers:


All times are GMT -8. The time now is 05:18 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website