grr radio install
hey fellas, im stuck in the middle of a radio swap.
I have a non-Bose system, CDR-220, and front amp/changer thing. I'm putting in a basic aftermarket headunit (from crutchfield, all adapters and wires are correct). I have the two harnesses correctly wired, and I get power on the unit and it appears to function correctly, but I get no sound at all. There are two stock harnesses, one thin, the other pretty wide. How do I take the cd changer out of the "loop" or if it's necessary, how do i hook it up correctly? The 4 speaker wires are correctly color-matched to the wiring adapters 4 speaker wires (2 grays and 2 whites). On the adapter that came with it, there are also 2 greens and 2 violets that I did not use. What did I hook up wrong? Also, I disconnected the alarm's spade connector from the metal housing, do I just leave this hanging when I reinstall the new unit? |
upon further inspection, it appears that while I DO have the 4 "speaker" wires connected correctly, nothing is plugged into it at the adapter so it isn't affecting anything anyway.
I managed to get sound now, apparently I misread and the "remote system" (blue and white wire) needed to be connected. So now I have audio! Now I need to figure out how to route the USB cord to the center console lol. |
Quote:
You can run it into the batwing, which just pops out with gentle persuasion. Blank batwings are $6-7 at Suncoast if you do not want to cut the original. I put my radar detector remote in a blank one with some careful Dremel trimming work. Or run to ash tray or armrest (slightly harder). Or over to the glovebox if you have one. I didn't check your year. |
All times are GMT -8. The time now is 02:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website