MOMO Steering Wheel Airbag Sensor?
 

For those of you that have replaced your stock steering wheel/airbag with a MOMO non airbag wheel, what is the trick to not tripping the airbag light?
Thx

You could always just remove the bulb. No more annoying airbag light!


Sent from my iPhone using Tapatalk

Good point!

works bell has a nicely packaged airbag plug kit/male harness. If you google, theres a couple places that has em for about $40. I use this as it came with my wheel.
Other option is resistor. Doesn't look as pretty but gets the job done 2.2ohm 1/4watt

i believe part number is WB-010021 yellow wrapper

I took the airbags out of my doors and passenger side dash. The only airbag I have left is the steering wheel and that's because I haven't bought an aftermarket steering wheel yet. I second the idea of just removing the bulb. It's free and only takes 5 minutes.

If you have a scanner or access to a scanner that turns off airbags...Airbagsystems can make you an airbag shunt. Very easy to install and convenient to pay the extra $$$. Just send them an email with car details and your good. I still haven't figured out how to wire my horn but at least my airbag light is off :)

Buy a spare clock spring and use the yellow plug to wire a resistor to, fairly simple to do.

As for the horn you need the 'L' shaped contact from the 993, run a wire from that to the red plug and you'll have a working horn. Total cost in parts was less than £20.