Broken O2 sensor male connector
 

Gents, need some help. As I was removing the O2 connectors to replace my exhaust I accidently broke the male connector of the O2 sensor. Its the one that is right under the trunk in the rubber grommet. Any idea if they have a replacement for this? Part number?

Exhaust is on hold until I figure this out.

Any help is appreciated.

Thanks!

Here's the link to the connectors you choose from (male / female):
http://986forum.com/forums/boxster-general-discussions/78147-02-sensor-wire-question-header-hi-flow-cat-install.html#post619783

Thanks Pilot. After doing some more reading I opted no to splice into the harness. The male connector had enough meat left that I was able to zip tie the o2 sensor and appears to be fine.