986 no crank

[Stl-986]

Let's start over. lol

You replaced the positive cable right? Did you disconnect the negative cable when doing this?

What I would do is 1st start checking your fuses. get a multimeter and check continuity on all of them. Do not rely on just visually checking. If all test good, next test the fuse at the immobilizer. Make a note of any that you replace.

Not sure what the nss is you refer to.

let's go in steps and not just throw out 50 different things that it could be, much easier that way.

[maybe368]

I am very happy right now because all I did was move the driver’s seat back, a ding ding ding happened and it started ���� Now dose that mean that the seat is interacting with the immobilzer? Thanks from a happy guy.

[maybe368]

Thanks JFP for the info I really appreciate it. I knew that it had to be something that I had done and I had adjusted the driver’s seat. When I went to look at the clutch safety switch and I pushed the seat back and a sudden ding ding ding. The seats have been reupholstered a couple of years ago so maybe there is some contact...Mark