Short-shifter adjustment assistance needed
 

As I’ve got some end-to-end play in my short shifter (B&M) and figured I’d tighten it—
I just can’t seem to get enough clearance to insert the hex into the end of the thread set screw—do I really need to remove the center console or is there a trick?

Attaching photos does not seem to work at the moment, will see if I can upload somewhere else.

Hmmm, tried to upload the image here: https://i.imgur.com/EQpQN4dr.jpg

I just cut out some of the plastic on mine. Now adjustment is quick and easy no fuss. If I had to do it again I would use a Dremel and keep a vacuum handy.

Hmmm, that did cross my mind. Making a cutout for tightening will be rather non-obtrusive, and will be hidden by the shifter boot.

Unless anyone else has any ideas I'll go ahead and start cutting up my center console ;D

UPDATE: The weirdest thing: I trimmed away the plastic that was getting in the way, but I just can't seem to adjust it anyway? There is about 1-2mm play laterally in the frontmost bushing, but it doesn't seem to want to have anymore tension. What have I missed?

Did you put the washer-looking spacer in between the bearing/cup and the shifter stub? I have Ben's shifter and it includes this - not sure if your kit does too. Ben used to have you use a penny as a spacer, now he includes a metal spacer for the same purpose. Again, not sure about your kit, that's all I can think of.

Thanks Doug!

I did solve the problem, it was just me making the wrong assumptions. Shifter now has 0 lateral play and the "bolt rifle action feel" is back :)