H&R Street Sport Coil Over Ride Height LOW
So I bought a set of these used from a forum member last year. I installed them over the winter and just gave the vehicle a test drive. During the install I was concerned about the right height in the front being too low and it definitely is. I’ve got it cranked all the way up to the maximum height and I even put an extra thick rubber shim/compensator on the top between the strut mount and the spring. Other than changing the springs any suggestions on increasing the ride height 1/2 to 1 inch? And if changing the springs is the only option anyone familiar with the correct spring to use?https://uploads.tapatalk-cdn.com/201...0d493b29f5.jpg
|
Are your front brake rotors backwards? That's the 2nd one I've seen like that and now it's got me wondering if mine are the ones that are backwards ;)
|
Quote:
|
Quote:
With regard to the car, it does look really good lowered like that though ;) |
I’m pretty sure those vanes in the front rotors are direction specific. Every single brake rotor (maybe the solid discs are an exception) I have ever seen listed are L R with different part numbers. The holes should sweep in the direction of rotation. And as mentioned, the stance does look cool, which is a bummer because driving over any bump would be challenging! I’m thinking springs are the only way to fix that correctly. As you purchased them used, the springs just might be dead. Or the compression dampening is shot.
|
Shocks were “lightly used” but my testing before mounting showed the damping in compression and rebound is good. Springs rarely go off, despite the Internet lore suggesting so. I do think spring replacement is the only fix since adjustment isn’t getting the job done. If there is no prior knowledge on this i’ll have to contact H&R - I was hoping someone else had done a spring swap.
|
Quote:
|
I bought a set of Yellow speed racing coil overs .When I went to install them thought I had the same problem .So I made a drawing of the lower bracket that has 1.0 inch of additional thread they agreed to make them for 50 bucks a piece . They were for 52 mm shock body with a 1.5mm pitch what are yours?
|
All times are GMT -8. The time now is 06:51 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website