986 Forum - The Community for Porsche Boxster & Cayman Owners

986 Forum - The Community for Porsche Boxster & Cayman Owners (http://986forum.com/forums/)
-   Boxster General Discussions (http://986forum.com/forums/boxster-general-discussions/)
-   -   Durametric Code 9114 PCM?? (http://986forum.com/forums/boxster-general-discussions/63493-durametric-code-9114-pcm.html)

binkoba 10-08-2016 07:46 AM

Durametric Code 9114 PCM??
 
I just got my Durametric cable and scanned my car,

the only code I cannot reset is

Instrument Cluster K21
9114:
PCM Control unit

Does anybody know what this means? I cannot find any hits on the web, and my car did not come with PCM.

The original radio is out and replaced by an aftermarket unit.


Thanks
Ash

JFP in PA 10-08-2016 07:55 AM

P9114 is a dash cluster error, which may be related to your aftermarket radio install.

Pdwight 10-08-2016 09:34 PM

Aftermarket Radio
 
When you lock your car with your remote do you get a horn honk ?

If so that is an indication something is wrong, there was a pressure contact on my 01S that made ground with the factory head unit. Once it was removed it thought the radio had been removed and gave me a honk on locking the car. I disconnected the pressure connector and I think I grounded it or just unplugged it....it is a simple slide on connector....you might check this.

grc0456 12-27-2016 07:31 AM

I also got a new Durametric cable and scanned my 2003 Base. Everything looked good. There were a few "yellow" warning codes, likely the result of battery disconnect I did when taking the seats out for repair) that I could clear.

I could not clear "red" codes 9114 (Instrument Cluster K21 - PCM control unit) and 38 (Automatic A/C H01 - PCM CAN timeout fault).

The car has its original CDR23 head unit that I had to send away to Becker for testing (it was fine, the amp was not and was replaced with a reconditioned unit). The head unit does mysteriously power down by itself sometimes, but otherwise works fine.

The only thing I can think of related to the A/C is I fixed the common "blowing foam' problem and had the mixing flap out of the car to re-foam/tape.

The car runs like a top otherwise, and I'm not too concerned about these codes - but the OCD in me makes me want them to be resolved or cleared. Any ideas?


All times are GMT -8. The time now is 05:35 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website