Flywheel supplier says on occasion the teeth get damaged in transport and asked up to straighten them out and try it first.
Straightened the 3 bent teeth just after the gap. Re installed flywheel, Clutch and Transmission,
Did a test start - Fired up immediately - idled nice - WOOOO HOOOO
Putting the rest of it back together over the weekend - 4 months and $2000 later we got a winner.
What cheesed me is when we called the supplier when this started they had "no ideal what could cause this issue" Then when we pulled the flywheel and noticed the bent teeth and asked them what to do - "They had seen this many times ""Just bend them back in place"" I was so pissed off - Could of saved me a couple grand if they just said - Did you check the teeth on the flywheel as they sometimes get bent in shipping.
Really cheesed about that part - but live and learn and send my $$$$$s else where next time.
Peace Out to all those that thru out ideas along the way.
Linear Mode
