KTS-500 to OBDII pinout?
My KTS-500 to OBDII cable was hand made and apparentlyu had a bad solder joint. One wire is no longer soldered to the 20 pin KTS connector so I can't use my PST2 to reset my codes (aside from using the battery discconect method). I've done a LOT of searching on the internet, but could not see to find a DIY on how to make your own cable or a pinout for the KTS side of the cable.
Does anyone have a document with the pinout on it I can use to fix my existing cable? |
Well, I found the bad joint and fixed it. All is well, plus I have a pinout document if someone needs it. Just PM me.
|
All times are GMT -8. The time now is 04:48 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website