986 Forum - The Community for Porsche Boxster & Cayman Owners

986 Forum - The Community for Porsche Boxster & Cayman Owners (http://986forum.com/forums/)
-   Boxster General Discussions (http://986forum.com/forums/boxster-general-discussions/)
-   -   Too much oil? (http://986forum.com/forums/boxster-general-discussions/44090-too-much-oil.html)

RandallNeighbour 04-07-2013 02:19 PM

Too much oil?
 
Did an oil and filter change yesterday. Only put in 8.25 quarts and the stick is reading a tad more than full. Will it burn off or should I drain some?

JFP in PA 04-07-2013 02:24 PM

Pull the filter housing, it holds about 1/2 quart.

RandallNeighbour 04-07-2013 03:08 PM

Will more than what's in the filter housing drain out?

kjc2050 04-07-2013 03:36 PM

Quote:

Originally Posted by RandallNeighbour (Post 335662)
Will more than what's in the filter housing drain out?

Nope. My opinion, half a quart is a high estimate. More like 5-6 ounces.

grtc68 04-07-2013 03:52 PM

Cool, I didn't know that either. I just changed my oil and have been wanting to switch to the LN filter adaptor, now it will be a breeze and I can inspect the older filter.

schnellman 04-07-2013 04:42 PM

The book my indy uses indicates about a quarter of a quart more than my owner's manual says. And, a couple of times he has added too much. I use a long plastic tube and siphon the extra oil out of the opening where oil would normally be added. Sucks, but it works.

RandallNeighbour 04-07-2013 05:30 PM

Airline tubing for a fish tank?

kjc2050 04-07-2013 05:46 PM

Dropping the filter takes 10-15 minutes start to finish, no siphoning, no oil dripping off a siphon hose.

cas951 04-07-2013 05:50 PM

Definitely drain some. I personally prefer to have the level just below the full mark.

Keep in mind overfilling the oil level causes AOS failures.

DFW02S 04-07-2013 07:57 PM

The tech guru for the local PCA suggests that if you track it, fill to the top of the orange marker.

JFP in PA 04-08-2013 03:25 AM

Quote:

Originally Posted by schnellman (Post 335680)
The book my indy uses indicates about a quarter of a quart more than my owner's manual says. And, a couple of times he has added too much. I use a long plastic tube and siphon the extra oil out of the opening where oil would normally be added. Sucks, but it works.

I would be cautious about putting plastic tubing down either the oil fill or dipstick tubes (on cars with them) as there are a lot of sharp edged things the tube can get hooked on and make it nearly impossible to pull it back out. We have had to take a couple sump covers off cars whose owners tried to use commenrical vacuum tank systems to suck the oil out without jacking the car up. Bad idea..........

schnellman 04-08-2013 03:57 AM

Quote:

Originally Posted by RandallNeighbour (Post 335687)
Airline tubing for a fish tank?

That's what I've used successfully. Takes a a couple of minutes without having to get under the car. But, if it's a bad idea, I certainly don't want to cause anyone a problem.

RandallNeighbour 04-08-2013 05:46 AM

Quote:

Originally Posted by DFW02S (Post 335703)
The tech guru for the local PCA suggests that if you track it, fill to the top of the orange marker.

Dipstick or dash indicator?

Flavor 987S 04-08-2013 05:54 AM

Randall, just wipe the dipstick 137 times. Done.

CoBeerToad 04-08-2013 07:23 AM

Quote:

Originally Posted by schnellman (Post 335680)
I use a long plastic tube and siphon the extra oil out of the opening where oil would normally be added. Sucks, but it works.

:D:D:D I got it!

DFW02S 04-08-2013 07:32 AM

Quote:

Originally Posted by RandallNeighbour (Post 335740)
Dipstick or dash indicator?

The dipstick

RandallNeighbour 04-08-2013 05:45 PM

Dropped the filter housing and dumped some oil. It does make a bit of a mess though, so have your oil catch pan handy. Thanks everyone for the great ideas!

JFP in PA 04-09-2013 02:50 AM

Quote:

Originally Posted by RandallNeighbour (Post 335863)
Dropped the filter housing and dumped some oil. It does make a bit of a mess though, so have your oil catch pan handy. Thanks everyone for the great ideas!

Always the path of least resistance......

recycledsixtie 04-09-2013 05:42 AM

Quote:

Originally Posted by cas951 (Post 335691)
Definitely drain some. I personally prefer to have the level just below the full mark.

Keep in mind overfilling the oil level causes AOS failures.

This thread reminded me that my oil level was low- halfway between full and min. on the guage which I did on the last oil change. So be extra careful to avoid overfilling as it does not take much to overfill it. Yesterday I put a pint in and it moved the guage level to about 2 more bars. It is so easy to overfill it.:(


All times are GMT -8. The time now is 10:07 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website