Quote:
|
Originally Posted by Tool Pants
It is better to have 2 people.
Get pliers that have sharp teeth. Grab onto the round part facing you, and there is not much to grab because it is so thin.
Second guy reaches under the lid with a 8 mm socket. 1/4" drive. The second guy unscrews the nut while you keep the round part from spinning.
|
Tool pants.. thanks for your reply, this is exactly what I did, I even tryed to pull on the top part while unscrewing..
All your comment confirm me that I don't have a 'normal' situation here.
I guess the blades of the nuts went too deep into the stud so they won't unscrew, I guess the only remaining solution is to drill them..
Threaded Mode
