Smoked tail/side lights
Does anyone know how I should go about installing my new/used smoked colored tail lights/side marker lights I just got from a wrecked Boxster? Any special tools or anything I should know about before I take her apart? The car is new to me, so I am kind of apprehensive about doing this if it will be more than I bargained for.
|
Tail lights are easy.
Open the rear trunk, remove the light bulb tray, next remove the four bolts, not sure of the size but they are rather small. Pull the light away from the car. To fit the new tail lights inset the new lights through the 4 holes for the screws and attache the four bolts. Easy job. Gary |
i replaced my sidemarkers yesterday. just push the flat screw driver between bumper and sidemarker from tireside and pull the end away from the bumper. it pops right out. just reverse it to pop the new marker in.
|
|
Thanks!
Thanks guys! Can't wait to work on it this weekend.
|
The tail lights use an 8mm hex. I just put in de-ambered OEM tail lights a couple of nights ago. Don't forget to pull the foam gasket from the old tail lights and put them on the new ones. :cool:
|
All times are GMT -8. The time now is 08:39 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website