Still have it. jack@nimblemotorsports.com

Pmd on payment issue

Got the wheels yesterday. Thanks a lot!!!

What about these two flip up arm rests?

http://986forum.com/forums/uploads01...1430682124.jpg

Still have them $25 ea.

Can you please check your PM. Thanks.

Set of four calipers, worked fine before parting out. $375 inc shipping.

http://986forum.com/forums/uploads01...1430840714.jpg

The front calipers have been sold.
Rear calipers have been sold.

How is your drivers side headlight? Price?

Headlight is clear, $150 ea

Front Bumper shocks, bumper support, hood lifts
 

$50 for the front bumper shocks, $50 for the support.

Hood lift hinge and cylinders, works good, $50 pair

http://986forum.com/forums/uploads01...1431285750.jpg


http://986forum.com/forums/uploads01...1431285767.jpg


http://986forum.com/forums/uploads01...1431285781.jpg

Gauge Cluster - $150
 

Gauge Cluster $150

http://986forum.com/forums/uploads01...1431290514.jpg

Hi,

Small one, but do you have the front dash alarm sensor cover (http://986forum.com/forums/uploads01/Sensor+Removal1350768881.gif)

Thanks

still have it, make an offer on it..

how about a key, immobilizer and ecu?

Have a key and the immoblizer, but no ecu, so I gather that doesn't help, sorry.

Would you like a rear stablizer, or some front fenders, or how about a convertible top? :)

I'm getting ready to haul this car off to the crusher, so I'm wondering if there are parts that i should remove that are not obviously of value. Like the brake booster and brake master cylinder, the A/C components, the heater tubes, gas tank, that kind of stuff.
Without buyers (and hey gots lots of stuff still), it will just add to my junk collection, and I need to get rid of all my junk!

Jack,

I wish you were close by, I could pass-by and look to take what I needed...:)

Did you get rid of the engine? I was thinking of the pulleys...I have to fit my A/C in my conversion and am thinking of fitting a pulley at the back of the Warp 9 and making a metal bracket to fit the A/C unit using a belt...

Just a thought...since the pulleys will be at least the same width as the A/C pulley...

Do you still have the Horseshoe bezel for the Radio? How much shipped to Toronto?

Never had an engine, sorry.