LN Engineering Intermediate Shaft Bearing (IMS) Puller/Counterstay
 

Hi All,

I have an IMS Puller/Installer Tool Kit for sale. Used only 1 time.

Pelican Parts sells for $339.95 plus shipping & tax:1998 Porsche Boxster Base Convertible - Tools - Page 9

Here is the project I used it on: http://986forum.com/forums/performance-technical-chat/45685-oil-leak-pulling-trans-change-rms-ims-clutch-etc-2.html

I will sell for $250 + $15 shipping to Continental U.S.
PM for purchase. PayPal payments only.

I also have Rear Main Oil Seal Tool for sale: http://986forum.com/forums/boxster-parts-sale-wanted/53192-fs-rear-main-oil-seal-installation-tool-flywheel-side.html#post409787

http://986forum.com/forums/uploads01...1405275074.jpg

You do realize that if you used that RMS tool to install the latest PTFE seal, it is installed at the wrong depth? The correct tool does not look like that one, and that is the old tool for the old style seal that is no longer used.....

Thanks. I did measure the depth of the install.

Which was?

I don'tont recall. I think it was 13 or 14 mm.

BUMP - This IMS Tool is still available.

BUMP $200 + $15 shipping to Continental U.S.

Interested in this and your RMS tool if I can get a discount for both. PM sent.

Is this still available or sold?

Sold a while ago.