Parting out 2001 S 3.2 Engine!!! Take a look!
 

Hey guys (and gals):

If any of you followed my thread over the summer for my2001 S 3.2 engine with a knocking noise I have finally found a really clean, low mileage donor engine to swap into my S.

So with that being said I am going to part out all the great parts that still remain from my original 3.2. This engine suffered a spun rod bearing on the #6 cylinder. It damaged that crank journal and began to damage the rear most main bearing journal. Just prior to me tearing it all down I installed new lifters, and IMS bearing (PP kit). All these parts had 37,965miles when removed.

I am going to write the list below and I will post pictures over the next few days as I clean up and organize more of the parts (so keep checking back as this list will probably get updated frequently).

If you are in need of a certain ENGINE part let me know and I will tell you if I have one available.

Please let me know if you think any of these parts are way out of line. I have only done some quick research around here and on eBay to see what they're worth.

Intake Manifold w/ TB- $250

Cylinder Heads w/Oil pumps and Cams- $750ea. OR $1250 for both

Engine Case (#6 cylinder was lightly scored GREAT if you want to do a engine build and sleeve this case) $300 SOLD

Crankshaft and Carrier- again #6 rod journal is scored as well as the rear most main bearing journal. This may or may not be able to be machined to accept and oversized bearing. I'll leave that to someone else's call- $300

Rods and Pistons- Are these really worth much? #6 bearing was spun. $150 for all??

IMS Shaft, bearing, chains $???? SOLD

Tensioners $40ea?

Wiring harness (excellent condition- no cuts)- $220

Alternator- $80

A/C comp- $80

P/S Pump w/res- $80

H20 Pump- $60??

Any sensors on the engine (not including O2) $25 each


The buyer will be responsible for the shipping on any of the above items. These items will be shipped from Greenwich, NY 12834 or you can pick them up locally.

Again if there is anything else you might need let me know I probably have it. The new engine came with everything you would need except the front motor mount.

You can PM me or email me at joewilson49 at gmail dot com for a faster response

Thanks for looking!

I'll take the block and the IMS. Send me a PM :-)

sent PM Jake!

There are no undersize bearings for the crankshaft, but I would give $150 for the crank shipped to CA so I can use it to balance a clutch & flywheel. I can do a set for you too.

ByPro I will find out how much shipping will cost and send you a PM. What is your ship to zip?

It's 92627

PM replied

Bump!!! Somebody needs 3.2 heads, or maybe a motor mount? How about YOU?! I heard you need a wiring harness??

pm sent Casey

Have not seen a PM

Passenger cylinder head sold.

ByPro I thought I had PM'd you. Sorry. Will do now.